ESA 8 bit Microcontroller Trainers

ESA 31

8051 based Microcontroller Trainer

  • Works with Intel 8051 based controller Operates at 11.0592 MHz
  • Operates on 5V Power Supply
  • Peripheral controllers: 8155, 8251, 8279, 8253 and 8255
  • Stand alone user interface is 7-segment display and on board key pad. RS232 for serial mode
  • Built-in one line Assembler/Disassembler in serial mode
  • Provision to work with Interfaces

ESA 51E

8051 based low cost Microcontroller Trainer

  • Works with Intel 8051 based controller. Operates at 11.0592 MHz
  • Operates on Single 5V Power Supply
  • Peripheral controllers: 8042, 8253, 8155 and 8255
  • Stand alone user interface is 20x4 LCD and PS2 Keyboard. RS232/USB(VCP) for serial mode
  • Built-in one line Assembler/Disassembler
  • Provision to work with Interfaces

ESA 51

8051 based Advanced Microcontroller Trainer

  • Works with Intel 8051 based controller. Operates at 11.0592 MHz
  • Operates on Single 5V. Optional ±12V Power Supply required for Optional ADC and DAC
  • Peripheral controllers: 8042, 8253, SCN2681, and 8255
  • Optional on-board 12 bit ADC 1674 and 8 bit DAC 0800
  • Stand alone user interface is 20x4 LCD and PS2 Keyboard. RS232 for serial mode
  • Built-in one line Assembler/Disassembler
  • Provision to work with Interfaces

ESA MCB 51

8051 based Single Chip MCU Trainer

  • Works with AT89C51ED2/RD2 Operates at 11.0592 MHz
  • Operates on Single 5V Power Supply
  • The power full on-chip flash monitor provides communication with Keil μ Vision Debugger
  • On-board ISP support for On-chip flash programming
  • On-Board LCD (16x2), interfaced to port lines.
  • On board UART to USB convertor
  • Provision to work with Interfaces
  • Push buttons for INT0 ,INT1 and Reset

ESA MCB 51-2

8051 based Advanced Single chip MCU Trainer

  • Works with AT89C51ED2/RD2 Operates at 11.0592 MHz
  • Operates on Single 5V Power Supply
  • On board UART to USB convertor, 8255 PP, ACE TL16C550 for RS-232C port
  • Powerful monitor in EPROM helps in integration of MCB 51-2 with Keil μVision Debugger
  • System configuration using on-board DIP switches
  • LEDs connected to port P1 for program testing
  • On-board EEPROM (24AA010) with SPI interface
  • Push buttons for INT0, INT1 and Reset
  • Supports ISP, Keil Debugging, and Provision to work with Interfaces