Preloader

ESA ARM Evaluation Boards

ESA KEIL MCB 2140

ESA KEIL ARM 7 Evaluation Board for LPC 2148

  • 60 MHz ARM7TDMI processor- LPC 2148 based MCU
  • On-Chip Memory: 512KB Flash and 32KB RAM
  • USB 2.0 Full Speed – USB Device
  • 2 Serial Ports, SD Card Interface and 2 push-buttons
  • Analog Voltage Control for ADC Input
  • Amplifier and Speaker
  • Debug Interface Connectors 20-pin JTAG (0.1 inch connector)
  • Provision to work with Interfaces

ESA KEIL MCB 1760

ESA KEIL ARM Cortex-M3 Evaluation Board for LPC 1768

  • 100MHz ARM Cortex-M3 processor- LPC 1768 based MCU in 100-pin LQFP
  • On-Chip Memory: 512KB Flash and 64KB RAM
  • Color QVGA TFT LCD
  • 10/100 Ethernet Port
  • USB 2.0 Full Speed - USB, USB-OTG, and USB Host
  • 2 CAN interfaces, 2 Serial Ports, SD/MMC Card Interface, 5-position Joystick and push-button
  • Analog Voltage Control for ADC Input
  • Amplifier and Speaker
  • Debug Interface Connectors
    - 20-pin JTAG (0.1 inch connector)
    - 10-pin Cortex debug (0.05 inch connector)
  • Provision to work with Interfaces

ESA KEIL MCB 2929

ESA KEIL ARM968E-S Evaluation Board for LPC 2929

  • 125MHz LPC2929 ARM968E-S processor-based MCU in 144-pin LQFP
  • On-Chip Memory: 768KB Flash, 56KB RAM, & 16KB EEPROM
  • External Memory: 1MB SRAM
  • Color QVGA TFT LCD with touch screen
  • USB 2.0 Full Speed - USB, USB-OTG, & USB Host
  • 2 CAN Interfaces, Serial Ports, 5-position Joystick and push-button
  • MicroSD Card Interface
  • Analog Voltage Control (2) for ADC Input
  • 20 PIN JTAG (0.1 inch connector)
  • Provision to work with Interfaces

ESA SEGGER EMPOWER

ESA SEGGER emPower Evaluation Board

  • Kinetis MK66FN2M0VMD18, 180 MHz ARM Cortex-M4 based core with DSP instructions and Single Precision Floating Point unit
  • 1.8" LCD module (resolution 160x128)
  • External debug interface (19-pin Cortex-M); incl. trace
  • USB device: High speed, B-type connector (as on J-Link)
  • 2 MB program flash memory, 256 KB RAM and 4 KB FlexRAM
  • NAND Flash 1GBit
  • Joystick 4(+1)-way, 3 expansion interfaces providing I2C, SPI buses, UART, GPIO/timer, analog input, power; compatible to 3.3 V SExI modules, Micro SD card connector
  • Two 16-bit SAR ADCs and two 12-bit DAC
  • Ethernet controller with RMII interface to external PHY and hardware IEEE 1588 capability
  • USB high-/full-/low-speed On-the-Go with on-chip high speed transceiver
  • USB full-/low-speed OTG with on-chip transceiver
  • CAN, SPI, I2C and UART modules
  • Secure Digital Host Controller (SDHC)