Technica Engineering
Media Converters
The Media Converters of Technica Engineering are hardware devices that establish a physical layer conversion between Automotive Ethernet connections (100BASE-T1 or 1000BASE-T1) and any device with a standard Ethernet Network Interface Card (NIC) with an RJ-45 connector.
10Base-T1S Network Interfacer
With a total of 5 Ethernet ports, our Interfacer acts as a communication hub, seamlessly routing data between 10BASE-T1S and point-to-point ports.
MC1000Base-T1 MATEnet TC10
The MediaConverter 1000BASE-T1 MATEnet TC10 of Technica Engineering establishes a direct point-to-point conversion between Automotive ECUs using 100/1000BASE-T1 Automotive Ethernet and a Standard Ethernet
MC 1000BASE-T1 H-MTDTC10
The MediaConverter 1000BASE-T1 H-MTD TC10 of Technica Engineering establishes a direct point-to-point conversion between Automotive ECUs using 100/1000BASE-T1 Automotive Ethernet and a Standard Ethernet interface
MediaConverter MultiGigabit
The MultiGigabit MediaConverter from Technica Engineering establishes a direct point-to-point conversion between Automotive ECUs using any of 2.5/5/10GBASE-T1 MultiGigabit standards and a SFP+ module compatible with any MultiGigabit Ethernet interface.
SFP Module 1000BASE-T1 H-MTD
The SFP Module 1000BASE-T1 H-MTD is a solution to convert between 1000BASE-T1 and SGMII using an H-MTD connector. It fits into a standard SFP(+) (Small Form-factor Pluggable) slot and provides an Automotive Ethernet interface (100/1000 Mbit)/s full-duplex, on one single twisted pair cable
MC 1000BASE-T1 H-MTD
The MC 1000BASE-T1 H-MTD from Technica Engineering is a smart tool used in automotive product development to test electronic control units (ECUs). It creates the link between an onboard vehicle device based on 100/1000BASE-T1 and the network interface card (NIC) of a computer belonging to the testing and development set-up.
MC 1000BASE-T1 MATEnet
The MC 1000BASE-T1 MATEnet from Technica Engineering is a smart tool used in automotive product development to test electronic control units (ECUs). It creates the link between an onboard vehicle device based on 100/1000BASE-T1 and the network interface card (NIC) of a computer belonging to the testing and development set-up.
MC 1000BASE-T1 Nano MQS
The MC 1000BASE-T1 Nano MQS establishes one direct point-to-point conversion between automotive ECUs using 1000BASE-T1 (1000 Mbit/s Fullduplex, with 1x Twisted Pair cable) and any Standard Gigabit Ethernet (1 Gbit/s, 1000BASE-T) device with an RJ-45 connector.
MC 1000BASE-T1 BCM
The MC 100BASE-T1 BCM from Technica Engineering establishes a direct point-to-point conversion between automotive ECUs using 100BASE-T1 (100 Mbit/s Fullduplex, with 1x Unshielded Twisted Pair (UTP) cable) and any standard Fast Ethernet (100 Mbit/s, 100BASE-TX) device with an RJ-45 connector. In the conversion, no packets are stored or modified. The conversion takes place on the physical layer with the highest proven reliability.